Quote:
Originally Posted by Alan's Classic
Very nice work!
|
Thanks
I'm making some progress it is slow going but none the less progress. I really don't recommend doing what you see in these pics unless you do a good bit of studying
Made my cuts, my first mistake as I should have cut the replacement part open first in my opinion I would have known a little more about what was behind it all
Cut the spot welds that I could reach had to drill the ones where the dash was, which caused some frustration but not too much
Here I was having some trouble getting the part out because of the sandwiched metal between the inside and outside panel, it took me awhile to figure out what was holding that part in place
After I got it all out and ready for the new part to go back in place
Cut out the replacement and then I could see what I should have seen before I started on the endeavor