Quote:
Originally Posted by spankbomb
From what I understand, the lowers should be horizontal and the uppers should be slightly angled down.
As far as the pinion angle, from what I undertand if your trans output is at -3 deg, then your pinion angle should be +3 deg.
Building adjustability into your link system can help tune it.
http://67-72chevytrucks.com/vboard/s...=366409&page=3
Later,
Jon D.
|
Thanks spankbomb, that shouldn't be to hard to accomplish. I guess I'll just set the rear at O* and make sure that Im able to dial in the wishbone a few degrees. I dont know where the trans will be set yet so better safe than sorry.
Thanks