Re: Project 67 DRGNWGN - 67 Burban!!
and cut out...the holes you see at the top is from me with the grinder and screwdriver trying to get the spot welds off (same mistake i made on the other side lol)
and after looking over the entire floor, this is pretty much all i have found in rust, other than a few scaling.
i believe i will fix this before i weld on the rocker. the only problem is i dont have a patch for it, but i do have a scrap hood i have been holding onto just for this reason. so i will have to make one. the only thing i need to figure out is what to do at the bottom that meets the floor. this area is where the 4th door would be, so its going to be tricky. good thing is carpet will be covering it, so im not too conerned on the final look but i would like it to look decent!
__________________
67 1/2 ton Suburban - Project DRGNWGN. Build thread
-_--_--_ _________
_--_-_ -/____|__|__\__
,.,,,.,.,,.,|_O _______ O_]
Last edited by kev2809; 10-18-2010 at 07:54 PM.
|