Re: One Piece Window Conversion Kit for '67-'72 GM Trucks
Hey there,
Just stumbled upon this review section too..
Anyway, I used the One piece products window conversion. In fact just finished installing it only a few days ago. 68 chevy with their power set up. The window kit is installed and I have tested with temp power a half dozen times. I hope it holds up over time, but with my specific doors I got lucky- fit and works pretty darn well. My one problem area is it is about a 1/4" above the door edge- flush with the rubber of the scrapers (and yes I cut an extra notch into the gear spool and then some). It took me a good eight hours of adjusting once they were in. I didn't have to grind on the latch or the door bottom/edge-it is very close though. I hope they continue to work well because they look spectacular. (pics coming soon)
|