[Ironhorse]

Wasn't really all that hard, just took some trial and error attempts. I bought a set of bench seat rails/mounting brackets from a board member who was trashing a seat. Done some looking and measuring and then cut just the mount brackets that had the floor mount bolt holes in them. If I remember correctly I had to trim the bracket down from the original heighth to get the seat to "feel" right. Still think I need to trim it some more to lower it some. Sits good but think I could get some more adjustment backwards if I lowered the brackets. I moved my in-cab tank to under the bed so have quite a bit of room behind the seat for storage. Truck is sleeping in winter storage right now so will have to wait for warmer weather.