The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

67shortie · 03-10-2011, 03:39 PM

Yes, this truck is a '71 with an early front clip.

Thank you Jay, I have 3 eyelet grounds, one at the alt mount and 2 that are bolted to the rear of each head. I will check those today, and I do not have the engine grounded to the chassis yet, that will get done as well.

If anything is out of place I will get it fixed and try again. I do have voltage while cranking fYI

Oh, another question, if I don't have all of the sensors plugged in yet would not the SES light pop on? Or does this come on only when it's all hooked up and running. I would think if I did not have everything hooked up yet it would go off.

03-10-2011, 03:39 PM	#108
67shortie Green club Join Date: May 2002 Location: Central CA Posts: 1,059	Re: Shreck's 6.0 build Yes, this truck is a '71 with an early front clip. Thank you Jay, I have 3 eyelet grounds, one at the alt mount and 2 that are bolted to the rear of each head. I will check those today, and I do not have the engine grounded to the chassis yet, that will get done as well. If anything is out of place I will get it fixed and try again. I do have voltage while cranking fYI Oh, another question, if I don't have all of the sensors plugged in yet would not the SES light pop on? Or does this come on only when it's all hooked up and running. I would think if I did not have everything hooked up yet it would go off. __________________ 71 short/fleet ECE 4/6 drop, LQ4/700r4/3.42 gears 70 SS396 Chevelle 427/200-4R/3.73posi 61 Lincoln Continental, black on black Son you are going to drive me to drinkin if you don't stop drivin that hot rod lincoln Last edited by 67shortie; 03-10-2011 at 07:50 PM.