The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

68 C-10 KID · 08-01-2011, 11:19 PM

Kevin,
So far all I can tell is it banged up my cross member destroyed the drive shaft, and spun the center section. I should know by next weekend what the in side looks like. I spun the yoke by hand and every thing looks good. I have a steel 1350 yoke on the pinion and it won the battle. I can't believe the mufflers didn't get beat up.

Fastwillie,
I'm not sure what it spun to. I can crawl under it tomorrow with a angle finder. The drive shaft was about 3*

I like the way you think BigDan. For now I'm just going to send this good used 12 bolt to the dutch man and have them weld it up.

08-01-2011, 11:19 PM	#48
68 C-10 KID Mean Green Join Date: Sep 2007 Location: Portland, OR Posts: 522	Re: Bullet proof GM 12 bolt. Kevin, So far all I can tell is it banged up my cross member destroyed the drive shaft, and spun the center section. I should know by next weekend what the in side looks like. I spun the yoke by hand and every thing looks good. I have a steel 1350 yoke on the pinion and it won the battle. I can't believe the mufflers didn't get beat up. Fastwillie, I'm not sure what it spun to. I can crawl under it tomorrow with a angle finder. The drive shaft was about 3* I like the way you think BigDan. For now I'm just going to send this good used 12 bolt to the dutch man and have them weld it up. Attached Images __________________ 427 SBC 683HP & 590ftlbsTRQ @ fly wheel. 60'-1.38 1/4-10.43 MPH-124.6 New ET current 4/2019 AKA MEAN GREEN.