The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

DT1 · 08-25-2011, 11:33 AM

I'm selling my 1990 GMC Sierra C2500 80K miles. The Engine, entire wiring harness, and fuel pump have been removed and are not available.
Was a California County Vehicle with only 80,000 miles. No rust or dents. Just a few minor dings. Nice set of tires. Hood and grill are in the bed.
Registered NonOp June 2011. Clear Title in hand.
I'll sell the entire truck for $600.00 OBO or will part out anything but the vehicle must remain a rolling chassis. The buyer of the entire truck must transfer title.

For my project I need a BellHousing to connect the 1990 SBC Gen I to an NV4500, Flywheel, Clutch, PressPlate, Hydraulic TO, Master Cylinder.
I have the 95 bellhousing and slave cylinder but would like to eliminate the bump by the starter and go internal with the hydraulics.

08-25-2011, 11:33 AM	#1
DT1 Registered User Join Date: Oct 2009 Location: Gardnerville Nv No Mo Cali!! Posts: 869	1990 GMC Serria for Resto or Parts I'm selling my 1990 GMC Sierra C2500 80K miles. The Engine, entire wiring harness, and fuel pump have been removed and are not available. Was a California County Vehicle with only 80,000 miles. No rust or dents. Just a few minor dings. Nice set of tires. Hood and grill are in the bed. Registered NonOp June 2011. Clear Title in hand. I'll sell the entire truck for $600.00 OBO or will part out anything but the vehicle must remain a rolling chassis. The buyer of the entire truck must transfer title. For my project I need a BellHousing to connect the 1990 SBC Gen I to an NV4500, Flywheel, Clutch, PressPlate, Hydraulic TO, Master Cylinder. I have the 95 bellhousing and slave cylinder but would like to eliminate the bump by the starter and go internal with the hydraulics.