So via pictures we have arrived at the "End of November"...
By this time the weather is telling us to pull my late grandpa's LWB out of the shop and get One Piece in or we won't be doing anything for the winter... Not a valid option as we need this truck ASAP to get back on the real project...
Let me bring everyone up to current with a few more pics, and then I'll try to be a little more diligent with the posts and updates.
Pass. Floor-pan work:
I also replaced the Pass. A-Pillar but there are no pics of this replacement...
After the floors and A's were done we put the truck in the shop and did a little primer work to keep the stuff we had fixed all buttoned up and rust free.
We took the Bed off and set it outside on a makeshift stand (4 cinder blocks and 2 4x4s) since we knew the rear crossmembers were total junk, we went ahead and removed the 2 that were present, and ordered the complete set from another board member. Since the frame is visible we decided to go ahead and wire wheel/grinder/etc.. all of the rust/tar/grime/nastiness off of it and shoot it with some Implement paint from Tractor Supply.
Pics:
(DWT cuttin up after we finished painting)