Quote:
Originally Posted by oldblue72c10
Ok the kickers are 4ohm so how do i wire them for 2ohm and get 200watts through each channel?
|
This is ONLY possible if your speakers are SVC...if they are DVC, you're only option is to wire them at a 4 ohm load.
Quote:
Originally Posted by oldblue72c10
Because it is a mono except split for two sub hook ups straight of the amp. I have two kickers in a truck box with one terminal on each side for each sub.
|
If your speakers are SVC, just connect speaker wires from the amp to the terminals and it will be wired as 2 ohm.
If they are DVC, you'll need to pull the speakers out and run a "jumper" from 1 negative to the other coil's positive, and connect opposing +/-'s to the terminal and then hook up the amp just like the above (see the diagram I posted for 4 ohm load).
Quote:
Originally Posted by stroker87
you can not get 200 watts per sub with that amp you can only get 200 watts RMS total @ 2 ohms
|
I thought the way it works is that if the amp puts out 200 watts at a 2 ohm load, it will be 200 watts to every speaker it's hooked up to as long as it's a 2 ohm load...am I wrong?