Quote:
Originally Posted by youngrodder
OKGMC4-
Do you mind showing more pics like the back of the light to show why you have to clearance the cab. Aslso some detail on the plastic fasterns. How did wire the light? Did you have wire it in any special way.
Nice work.
Marc
|
The nylon bolts are a number 4 machine screw. I got them with the nuts and spacers at Ace hardware. I needed to isolate the board from the metal light housing. I also had to raise the board up enough to clear the wires underneath. I got them extra long and once tight I cut the ends off and put a dab of gorilla glue on them to keep them tight. There are only two wires, red for 12v and black to ground. I probably could have used a smaller led panel but wanted it bright. Since the nuts stick out the back I had to open up four spots for them to sit in when the light is mounted to the cab.