Re: Rustbuket 67 build "Georgia"
Heres my "A" pillar almost finished up, I had correct a couple of the angles on it with a press brake to make it fit. then plug weld,plug weld,plug weld. make sure the upper hinge hole is 7.5" center from the fender flange on the bottom front of the pillar. I still need to cut out the front of the floor where your feet go and weld in the new one, Im thinking ill cut it out where i marked the photo, but not crooked, square off the edge where it meets the firewall. and fab up a piece to repair the offset flange of the firewall.
__________________
Dan <---(my name)
67 SWB C10 project "GEORGIA"- 59 Brookwood 2dr wag...Next project- 03 Tahoe 4x4 5.3 family ride- 07 Hondur Accord, commuter car
|