The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Alan's Classic · 01-26-2012, 11:27 AM

I use self tapping sheet metal screws to tack a panel in place.

It doesn't hurt to have your door on when doing the cab corners. If you run a straight edge down the rear pillar it will get you close. I always use the sheet metal for alignment. It takes the guess work out.
Posted via Mobile Device

01-26-2012, 11:27 AM	#239
Alan's Classic 1 thing at a time is progress. Join Date: Jun 2007 Location: Ball Ground GA Posts: 5,511	Re: Not Another Rebuild Thread.... I use self tapping sheet metal screws to tack a panel in place. It doesn't hurt to have your door on when doing the cab corners. If you run a straight edge down the rear pillar it will get you close. I always use the sheet metal for alignment. It takes the guess work out. Posted via Mobile Device __________________ Alan Philippians 2:14-16 Alan's Classic Facebook page. North Georgia Group Project 1965 Vitamin C-10 1995 GMC Sierra K1500 The "Wrecker"