The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 4-Wheel Disc Brake Line Bore

RdoubleU · 02-27-2012, 03:46 PM

Hoping CaptFab or someone else can lend some expertise/experience:

I am wondering if I need to route new brake lines and if so what bore size to compensate for the change from drum to disks.

Basically wanting to make sure i have proper pressure everywhere needed.

Current Set-up:
- Front : ECE Drop/Disk Brake Kit
- Rear: CaptFab D52 brakes (with the astro van rotors and caddi e-brake calipers)

Master Cyl :
- Wilwood Manual Master - Part # 260-8556-P

Currently I have the stock Drum/Drum Lines front to rear

Should I route new lines either with a pre-bent kit or bend my own, and what size line should i be looking for?

02-27-2012, 03:46 PM	#1
RdoubleU Registered User Join Date: Apr 2010 Location: AL Posts: 209	4-Wheel Disc Brake Line Bore Hoping CaptFab or someone else can lend some expertise/experience: I am wondering if I need to route new brake lines and if so what bore size to compensate for the change from drum to disks. Basically wanting to make sure i have proper pressure everywhere needed. Current Set-up: - Front : ECE Drop/Disk Brake Kit - Rear: CaptFab D52 brakes (with the astro van rotors and caddi e-brake calipers) Master Cyl : - Wilwood Manual Master - Part # 260-8556-P Currently I have the stock Drum/Drum Lines front to rear Should I route new lines either with a pre-bent kit or bend my own, and what size line should i be looking for?