I do believe sir that all the rad supports I have seen photographed lean inwards 1 to 3/4" at the top. There was quite a discussion on someone else more recent thread as well.
I have not mocked my all original body parts back up to check this, but that lean does seem to be intentional, or in the least a common design (flaw?).....
I did not realize that I had not read your entire thread before today.
Awesome work you have done here. Is your build timeline the same as your posting? If so you are just jamming along!!
Though I understand you have experience, help, tools, equipment, and probably time up on me
Your dash is looking super nice too, I dig your mods!
Thanks for the sq-ft info on the deadner, I would never have guessed you could use 50sqft inside a single truck cab like that.....
Also glad you mentioned the boxing in of your frame rear for tank protection. I am going to give mine a second look now too when I get back to that end of the rig.....
Keep it coming, I am digging this.