[67chevy1series]

ok was actually busy on the 67 today... problems before today: passenger door was hitting the fender right at the lower body line with the trim, sill plates not installed no wire hot wire to the distributor, driver door wasnt adjusted well, door jambs were dirty cab door latch mechanisms were rusty and not painted since 67 so today I:
drilled the three holes in the tin for the tach to screw into
cleaned the door jambs and installed new ( not new but ones from my other 67 cab that i cleaned and painted a while ago) cab door latch mechanisms ( for lack of a better term)
adjusted the passenger door
had to take the passenger door off to adjust the hinges so i sanded the door where the hinges bolt and primered and painted.
screwed the sill plates through the new carpet into the floor nicley. installed the plenum valve?? into the cowl
sanded primered and painted the fresh air vent for the passenger side.
and now time for pictures and less talky talky lol