The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

68 C-10 KID · 05-08-2012, 08:55 AM

Posted via Mobile DeviceI do the same, switch over to the bias drags at the track when I don't like to run the quick time pros. Yes I have them on the rear also. I tried the dodge master. The pattern was to small to bolt up to the Factory studs. So I used my ccp disc disc master and took off the prop valve. The pedal feels a little soft. I think it's due to the bore being 1-1/4" and not the 1-1/8" like recommended.

05-08-2012, 08:55 AM	#29
68 C-10 KID Mean Green Join Date: Sep 2007 Location: Portland, OR Posts: 522	Re: New rubber Whats next? Posted via Mobile DeviceI do the same, switch over to the bias drags at the track when I don't like to run the quick time pros. Yes I have them on the rear also. I tried the dodge master. The pattern was to small to bolt up to the Factory studs. So I used my ccp disc disc master and took off the prop valve. The pedal feels a little soft. I think it's due to the bore being 1-1/4" and not the 1-1/8" like recommended. __________________ 427 SBC 683HP & 590ftlbsTRQ @ fly wheel. 60'-1.38 1/4-10.43 MPH-124.6 New ET current 4/2019 AKA MEAN GREEN. Last edited by 68 C-10 KID; 05-08-2012 at 09:03 AM.