The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**29od1** · 06-09-2012, 11:23 AM

Hi Paul,

I have a working factory tach that only goes up to 3700 rpm then stops, but it does move freely by hand past that point and operates correctly below that rpm. I replaced it with a reproduction so I am not using it. I didn't want to take the time to try to get it working past 3700, basically because I don't know anything about them and didn't want to screw it up.

Anyway, I saw that you were redoing the rear tins on the factory tachs, and I was wondering if you'd take my tach in trade for a speed warning buzzer? We'd each pay our own shipping to get them to each other.

Let me know,
David

06-09-2012, 11:23 AM	#18
29od1 Senior Member Join Date: Oct 2006 Location: Wichita, Kansas Posts: 1,050	Re: 2 New speed warning buzzers F/S Hi Paul, I have a working factory tach that only goes up to 3700 rpm then stops, but it does move freely by hand past that point and operates correctly below that rpm. I replaced it with a reproduction so I am not using it. I didn't want to take the time to try to get it working past 3700, basically because I don't know anything about them and didn't want to screw it up. Anyway, I saw that you were redoing the rear tins on the factory tachs, and I was wondering if you'd take my tach in trade for a speed warning buzzer? We'd each pay our own shipping to get them to each other. Let me know, David