[QUOTE=Wasted Income;5679081]Got mine 90% finished up.
In my experience it hasn't been a 100% bolt in deal. Trim some stuff here, cut some stuff there, file these so they fit. I am hoping the steering doesn't end up being a headache, since I was planning to use a stock tilt column.
Gotta say though, if it works half as good as it looks, the tweaks required during installation will be worth it.[/QUOTE
The stock column will not work. You can see in the photos my new CPP column with the three u-joints did not work. I went with a ididit 30" column and flaming river u-joints that I picked up from Scotts, thanks Justin. You are also going to have to mod your trans cross member, shorten your drive shaft, mod your motor mounts and adjust your pinion angle ( with a gen 1 SBC). If you have a low hump cab it will be a tight fit. I will let you know how it performs after the Goodguys show, autocross in Arizona.