[Wasted Income]

Got a little bit done during the night this week.

Finally finished up the fuel system. Got the regulator and return line plumbed. Just need to clip the line to the engine once I figure out exactly where the AC compressor will sit.
Got the front drive accessories on as well, aside from the crank pulley and AC stuff.





Also got the master bolted up to the hydroboost, and plumbed to the prop valve. Need to set the body on the frame to finish connecting the brake lines.



And of course, the UPS and FedEx guys have been at the house daily, dropping off new stuff.

Back seat


Radiator


Wastegate


Power steering pressure reducing valve, so that the GM power steering pump doesn't blow out the seals on the Ford steering rack


Planning to spend a lot of hours in the shop again this weekend...