The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project 67 DRGNWGN

**kev2809** · 04-14-2013, 09:56 PM

Got the fuel line finished outback..i bent the stock line up the notch, bought a new flared line and bent that around the rest of the notch, connected the 2 together with a small piece of fuel hose and clamps, then ran about a foot of fuel hose from the tank to the hardline on the frame like the factory did. Not the most prfoessional setup, but it should work and will be covered by the floor anyways. Also installed new rear brake lines from lmc. Working on the fuel filler..and thinking of this....

Im going to have to use a spacer on the filler to mount it right...its at a small angle. Does anyone see a problem running in like this?
Posted via Mobile Device

04-14-2013, 09:56 PM	#669
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,134	Re: Project 67 DRGNWGN - 67 Burban!! Got the fuel line finished outback..i bent the stock line up the notch, bought a new flared line and bent that around the rest of the notch, connected the 2 together with a small piece of fuel hose and clamps, then ran about a foot of fuel hose from the tank to the hardline on the frame like the factory did. Not the most prfoessional setup, but it should work and will be covered by the floor anyways. Also installed new rear brake lines from lmc. Working on the fuel filler..and thinking of this.... Im going to have to use a spacer on the filler to mount it right...its at a small angle. Does anyone see a problem running in like this? Posted via Mobile Device __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]