|
Re: very frustrated
Hey everyone, so here's an update. I ended up pulling the engine and tranny out to replace the oil pan gasket and flexplate. Once it was out we saw the heads needed a valve job and the bearings were pretty scuffed. So off to be rebuilt she went. Money's been tight so I spent what I can cleaning up the engine bay and cleaning all the accessories because I can't just go buy everything new. Long story short, engine is in looks good and I just have a few loose ends, mainly a freakin starter that refuses to mesh with a flexplate. That was the original problem. I purchased a starter bracket from the oc truck shop and the holes don't line up. I'm drilling a hole into that bracket to see if I can make it work. I've been working on getting it drivable for the past week straight after work. Any advice will be appreciated.
Posted via Mobile Device
Posted via Mobile Device
|