|
Re: very frustrated
I wish I knew how to put up pictures from my phone on here I can show you what I'm dealing with, the reason for the shims is that I'm going off the little 1/8 inch rod that came with the starter. I believe it goes between the bendix shaft and flexplate teeth to check clearance. With no shims there was a big gap between the shaft and teeth, I put a couple of washers on the outside bolt and it got closer. But its still not close enough and it binds. I've been reading that orileys starters fit pretty good. Should I "START" off fresh with another starter?
Posted via Mobile Device
|