Hey all;
This one is for all you guys who have 71-72 tilt automatic columns.
After restoring one of these alot of guys find out that the pin used to hold the shift arm in place wont go back in tight well I came up with a great solution for this problem.
You will need to buy the following;
1x 8-32x3/4" stainless allen bolt.
1x 8-32 internal threaded sleeve with end stop.
Then drill out the bottom ear to fit the sleeve with a 9/32 bit and then countersink the shift arm approximately 1/8th of an inch with the same bit.