Quote:
Originally Posted by Bomp
From the original stock height of the '60-'66 seat to the '90 seat being modified(lowered), how many inches did you achieve?
|
I made a measurement from the floor (no carpet) to the top of the front edge of the seat and it was 14.25 inches. A few board members offered to measure their seats, so we'll see what the difference is very soon.
Quote:
Originally Posted by rusty76
This is what I'm talking about! Fellas take note.
|
I'm back on my game!! Feels good, too!!
Quote:
Originally Posted by McMurphy
I have a stock bench I can measure out for you.
It will be tomorrow at the soonest though, I am on duty tonight.
|
Thank You, Sir!!
Quote:
Originally Posted by Low Elco
Like the looks of it! I did my trams on the stand, highly recommended. Are you gonna use the BTO kit? I liked that it solved all the geometry probs in one whack. Are you gonna use a vacuum cutoff as well? Glad you're back on the job, as it were.
Posted via Mobile Device
|
Not sure what kit I'm going to use yet. I was thinking about just making the lock-up work off of a switch for simplicity, but the vacuum kit makes it real simple because the trans does all the work.
Brad did his TV cable using a factory bracket with a slight mod and it works great on his Holley. I might use the same set-up.
Bow Tie Overdrives is actually in the next town over. I've used their stuff before, and it worked good. You'd be shocked at how their place looks. They do a ton of business, but their shop is a dive. 99% of what they do is mail order, so it doesn't matter how nice the place looks. Those boys crank out some transmissions.