|
Re: Removing tie rod
A zerk fitting is for a grease gun chuck to lube the joint.
Some times you can get lucky and hit the stud end of the tie-rod with a large hammer (BFH). Do this with the nut on the threads, just loose.
Other wise you will need a "pickle fork" or tie-rod separator tool to remove the tie-rod stud from the tapper.
__________________
Mark
Jesus is the Way!
2003 2500HD CCLB Duramax/Ali (Clifford)
2014 2SS/RS black on black Camaro (Betty)
2006 Pontiac SOLSTICE silver/black (Lula-Bell)
1970 C/10 Short Wide (Peggy)
1964 C/10 Short Step (Hambone)
RIP Jimmy Hamilton Thank you for the trucks
|