Well first off, thank you
I appreciate the interest.
Not too much has been going on, it seems like anything truck related is going at a snail's pace right now.
I've gotten the engine to fire, it's run a few times for about 15 sec. I was going to post an update when I had the engine running reliably.
In addition to engine, and some bodywork to the cab, I've been tackling the brakes. In order to switch from drums to chevy discs, I need to make the hub smaller, so the rotor sit's on the hub correctly.
More information here.
So I have the hub at school right now, we getting ready to mil it out. I made copy of the hub on some 3D modeling software, then created the cut paths for the mill to machine it out. I'm just waiting for the teachers and I to find a way to secure the hub so it won't
shake, rattle or
roll while we're cutting.