Finally got a little progress to report. I braved the 40 degree weather and, for the most part, it wasn't that bad. It got a bit cold later in the day when it dropped back into the 30's though.
Finished installing the upper shock relocators, got the PB LCA in, bag and shock mounted, and upper bag plate tightened down. Still need to torque the spindle to the lower ball joint. My torque wrench only goes to 75 ft-lbs (3/8 drive) so I need to go get a 1/2 drive torque wrench for the bigger stuff.
Ordered some 90 degree unions for the air line so I can install my schrader valves in the frame rails... this is temporary, until I get the air management stuff. The schraders will be hidden in the engine compartment, so I just need to pop the hood to fill them up.
This is still just the passenger side...
On to the pics: