Re: 1966 Snub-nose C60 project
Here is half of the coupling device that will connect the engines together.
The part that is in the chuck was a balancer from a small block Chevy, fellow truck builder Tim Smith came up with all this. This will bolt to another sbc balancer that has been modified to fit the LS engine. Then we have a chain coupler from a machine supply, it has been turned down and opened up to attach to the balancer on one end and a input shaft on the other. The splined shaft will be stuck in a bearing in the rear of the crank of the second engine. There will be an apparatus on the splines that will allow us to connect and disconnect the 2 engines so we can shut the front engine down running down the highway.
Last edited by Scooterbilt; 01-15-2014 at 11:44 PM.
|