[Adambomb]

the box sides turned out pretty good.. an few minor imperfections, that I couldn't see before I shot it with primer. I read about using a guide coat on the auto body 101 site, so that's probably the next step to get them close to 100% before paint.

I tried to keep the bondo to a minimum, but because I've only welded a handful of things, I needed to add a bit here and there to smooth out my weld joints..
I ended up just cutting the whole rear post panel off the drivers side where I tried to make that dumb fuel filler and welded another one on from my spare longhorn bedsides..

I think I got lucky because the spare bedsides were all rusted out in different spots than my truck, which made it great for cutting and pasting..