Model: 1972 Chevy C10 longbed.
Motor/transmission: 2007 4.8 van motor / TH350 using Advance Adapters flexplate.
Fuel tank: Stock 1972 with in tank pump conversion.
Motor mounts: Homemade. I've posted
PDF templates if you want to copy them. Used the '72 engine stands set back to the six cylinder position. They had the "bumps" cut out, flipped side to side and upside down, and welded back in to clear exhaust manifolds.
Tranny mount: Stock.
Oil pan: Stock truck pan.
Radiator: Stock '72. Used 2005 Silverado hoses with about 2" cut off each end of the lower
Shift linkage:
Exhaust manifolds:
Gears: Stock, haven't checked what ratio.
Rear End: Stock '72.
Bagged: No.
Running: Yes.
Build thread: http://67-72chevytrucks.com/vboard/s...d.php?t=592021
Carb or FI: EFI. Stock injectors with MS3-Pro ECU.
Throttle setup Earlier cable operated throttle using a 3' mountain bike brake cable.
Go Fast: Motor is stock.