[61K10]

If you look at the piece that was cut out with the tape it's 1-5/8" minus 2 saw cuts which make it 1 3/4". my total length from center of king pin to drag ling hole is 6 3/8". now i have a dropped pitman arm, don't know if that will make a difference. I thank when i set it up i used the stock p/arm. I wounder fi you could just drill a new hole 1-3/4" shorter and add some more support around the tip? don't know what else to tell you. I will probably add some plates to mine just for piece of mind.