Re: 68 C10 Project FROSTBYTE Extreme Dropmember
Quote:
Originally Posted by jtp67-72
I like to use the bellhousing flange ( back of block ) or if intake is off lay straight edge across end valleys with digital angle finder I have...remember on most sbc intakes u can't use carb flange because it already has 3-4* built in to level carb when engine and trans are set to specs....I have used back of tailshaft too..........jim
|
Alright, cool, I'll check both those places too. I wish I had a digital angle finder, it would make things a whole lot easier. Should probably just go ahead and get one since I'll be using it quite a bit more. Thanks Jim.
__________________
Rick
1968 Chevy C10 Shortbed, 383 w/4L80E, Extreme Dropmember, Accuair I-Level, Bonspeed Big Blocks
|