The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Arekusu · 05-19-2014, 06:53 PM

How it sits under the truck. Last Pic is a cruddy one of the dyna pro wilwood brakes.

***Note *** My axle measurement wheel mounting surface to wheel mounting surface (without brakes figured in) with the 15x10 steelie wheel vintique rims was 56 inches wide. The 12 bolt pinion offset was .5" (Stock 1964 C10 axle width is around 62" wms to wms )

I had moser figure how wide the axle really needed to be with the disk brakes included. I saved about 500-700.00 on the axle by NOT buying the muscle pack kit. Shipping was going to be expensive. So I had them piece the kit together and send it in 3-5 boxes. I assembled the differential ( really easy actually, the chunk is pre assembled when you get it), moved the brake line mount for the flex lines (forgot to tell them there would be interference.. my bad) and then installed it. Wavetrack 3.75 gears, back brace, aluminum center case, 1350 yoke, 35 spline axles, semi gloss black powder coat.. It should never die.

Alex

05-19-2014, 06:53 PM	#23
Arekusu Registered User Join Date: Mar 2008 Location: Tacoma, Wa Posts: 334	Re: Old School Hot Rod Truck (1964) How it sits under the truck. Last Pic is a cruddy one of the dyna pro wilwood brakes. *Note * My axle measurement wheel mounting surface to wheel mounting surface (without brakes figured in) with the 15x10 steelie wheel vintique rims was 56 inches wide. The 12 bolt pinion offset was .5" (Stock 1964 C10 axle width is around 62" wms to wms ) I had moser figure how wide the axle really needed to be with the disk brakes included. I saved about 500-700.00 on the axle by NOT buying the muscle pack kit. Shipping was going to be expensive. So I had them piece the kit together and send it in 3-5 boxes. I assembled the differential ( really easy actually, the chunk is pre assembled when you get it), moved the brake line mount for the flex lines (forgot to tell them there would be interference.. my bad) and then installed it. Wavetrack 3.75 gears, back brace, aluminum center case, 1350 yoke, 35 spline axles, semi gloss black powder coat.. It should never die. Alex Attached Images Last edited by Arekusu; 05-19-2014 at 07:24 PM.