Quote:
Originally Posted by Xeen
It's not supposed to do that, I'm guessing you bought a cab/bed mounting kit, well did you have any washers left over?
If not you may have too many washers on the wrong side of the frame mounts.
|
Well it happened because the rear portion of my floor is stock suburban and in the suburban the trailing arm crossmember is farther forward then it is now. I added like 20 some inches to the wheel base so there is no clearance in this area of the floor to clear the crossmember. It is not a big deal I knew it was close, just need to decide how I want to fix it. This is one of the things I would have done different if I started this project today I would of used the truck cab floor in the rear and I wouldn't of ran into this problem. I am also going to have to fab all seat mounting points as well because of this.