Quote:
Originally Posted by cableguy0
When you are done with this thread I will make it a permanent sticky so its easily found. Your doing a great job explaining everything. Thank you for sharing with everyone.
|
Thanks man!
On to the Input Drum, I didn't instruct to disassemble this drum for a reason. We need to leak test it first.
Take the SunShell that your going to replace & cut the splines off flush with the Shell, This will be your Test stand & Pump stand.
Lubricate the 2 sealing rings on the back of the pump with TransGel or Vasoline.
Do the same with the 4 on the Input shaft, Slide the pump onto the Reverse Input drum/Input Drum assembly (with the plastic thrust washer), Grab the whole assembly with one hand on the pump cover & the other on the end of the Input drum, Flip it upside down onto the test stand.
Reverse Input/Input Drum.
Assembly stacked upside down.