View Single Post
Old 08-08-2014, 08:55 PM   #62
clinebarger
Senior Member
 
Join Date: May 2009
Location: Fort Worth, TX
Posts: 6,370
Re: 700R4 build thread.

Up next is the Center Support.
Install New Low/Reverse Sprag, Install Inner Race.

Look at Center Support, There is a notch that's wider than the rest, Match it to the wide Lug in the Case.
Sit the Center Support down in the Case, Rotate the Low/Reverse sprag race 'till lined up.
Use a Hammer Handle to seat the Support to the Case.
Inspect the Anti Clunk spring (see pic)
Install Snap Ring, The White marks are where the ends need to be.
Attached Images
 
clinebarger is offline   Reply With Quote