The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

MP&C · 08-30-2014, 05:51 PM

Today we worked on tying up some loose ends. We had a slight mis-alignment at the front corner of the passenger door..

The lower hinge had already been adjusted as far as the floating nut would let it...

So the door was removed, and since we have no milling machine, we went through about 8 of these 60 grit sanding discs..

For a better comparison, here's the before again...

After

08-30-2014, 05:51 PM	#195
MP&C Registered User Join Date: Jan 2013 Location: Leonardtown, MD Posts: 1,636	Re: 55 Wagon Progress Today we worked on tying up some loose ends. We had a slight mis-alignment at the front corner of the passenger door.. The lower hinge had already been adjusted as far as the floating nut would let it... So the door was removed, and since we have no milling machine, we went through about 8 of these 60 grit sanding discs.. For a better comparison, here's the before again... After __________________ Robert