While Kyle was working on dressing some welds this evening, I took some time to planish the weld on the driver's fender eyebrow. Here's the previous.....
It had a noticeable dip throughout the weld seam. Here's the tool used.....
The eyebrow on the passenger side was planished all by hand, and probably has a couple hours of work. The Watervliet planishing hammer made short work of the driver's side, it took all of five minutes time to have it in a comparable state as the passenger side... with the dip all but disappeared
Continuing on with more inner fender work, starting on the driver's side....
Back side, full penetration welds.....
Staple holes for seal filled...
Should get both these finished up Saturday morning and mocked up with the battery tray..