Re: 700R4 build thread.
3-2 Downshift Control Valve
Remove the Roll Pin, (Place finger over the hole, This spring will launch into orbit).
If you want a easier 3-2 Downshift, Omit the Spring, (I would leave the spring out, & see how you like it) If the 3-2 downshift is to active for your liking you can reinstall the stock spring.
If your shift kit comes with a 3-2 valve spring, DO NOT use it! It is generally stiffer than the OEM spring making 3-2 downshifts hard to obtain.
Install the Valve as shown below.
Followed by the spring if you want it.
Install the Roll Pin through the top of the Valve Body, So you can remove the roll pin without dropping the Valve Body.
|