Quote:
Originally Posted by 1rippen6
It appears that the transfer case linkage that the shifter connects to is missing the pin. I think the linkage should have a pin at each end if I am not correct I am sure someone will chime in. I believe it should be silver soldered or some kind of brazing to hold it in.
|
It didn't seem unusual at tear down, I would welcome comments on this...Dwayne you're sending me scurrying through posts to see if my shift connection had been rigged up. My shifter connected to the linkage shown with a bolt/bushing/pin set up. The shifter is currently at the chromer.
Quote:
Originally Posted by mx289
Great build you have going here.
That chassis looks amazing !
Very good attention to detail.
|
Thanks.