|
Re: Porterbuilt control arm help
Quote:
Originally Posted by PBFAB.COM
No washer gets installed there.
The crush tube will bottom out on the machined collar of the shaft.
Make sure the bushing shoulder seats against the outer edge of the control arm pivot tube (the machined sleeve that the bushing slides into) then tighten her down until the crush tube seats against the shaft.
Fee free to send me an email with any questions! Tech@pbfab.com
Nate |
Any torque specs for the bushing hardware?
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 01-12-2015 at 12:36 PM.
|