Ever wonder what runs a heated paint booth?
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20150122_202625.jpg)
Kinda hard to see but it gets up to 145 degrees. I was hanging out in there because it was so damn cold (for California...lol)
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20150122_204541.jpg)
Back to the truck....I wasnt happy with the gaps on my truck. I could get the fender gaps right but then the cab was off. Got the cab to match then the front wouldnt. So.....off with the mounts:
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20150124_140545.jpg)
Smoothed the weld for more clearance but decided to section the frame anyway:
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20150124_140552.jpg)
Where the mounts needed to be
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20150125_155254.jpg)
Cut lines
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20150125_163312.jpg)
Cut
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20150125_170723.jpg)
Sectioned 1/2'' and put it back with the new mount holes.
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20150125_181550.jpg)
I'll clean it up and weld it back in later. I needed 3/16 of an inch to clear so I gave myself 1/2''. The mounts needed 5/8'' so I went with 7/8'' so I could adjust more if I needed to but everything should fit much better now.