Quote:
Originally Posted by randomco
Ok, got the steering notches in and started to bolt on the front crossmember and ran into my first problem...
I've drilled out each frame hole to 9/16th's as instructed in the procedure, and have my two front bolts in. However the rear 2 holes in each side do not line up properly to get the other 4 bolts in...
BTW the very front factory crossmember is still in, the instructions didn't stay to remove it but I've seen most PB trucks with it out.
Any ideas from the experts??
|
I'm hardly an expert but I took mine out. Use some ratchet straps to bring the frame rails together to line the bolt holes up. That worked for me. Hope that helps.