Quote:
Originally Posted by 61superman
ok @robnolimit you mentioned it would or should work fine with a Z'd frame what about a stock pancaked crossmember (2in)? instead of bolting the bracket on could i weld it in place after of course making sure i was centered etc? any info from all would be appreciated or and other suggestions
its a 1963 suburban
2in pancaked stock crossmember
thx in advance
|
The trick would be to keep the relationship (elevation) from the LCA mount to the rack pivot points the same. So, if you set the mount bracket on the crossmember as designed, the geometry should be fine. Now, mounting the bracket may require welding in your case. Also, rack - to - engine clearance may be slim. Did you raise the motor at all?