|
Re: Lss3
I finished measuring the frame and drawing it on the layout table, then drawing the fuel line. I did a test bend with aluminum tubing and tried to weave it into the frame. No luck. The tube got mangled. Maybe the stainless tubing would have sprung back, but I decided not to chance it. I added a bulkhead fitting to the cross member in front of the fuel tank. This way the fuel line can be split in two. There will be fewer obstacles for each piece to work around.
I got a couple of parts to start my intake system, both from Spectre Performance. The flexible elbow is part number 9785 and the mass air flow sensor 9718. I still need to figure out an air cleaner and housing. It needs to pull cool air from in front of the radiator.
|