The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**raggedjim** · 09-24-2015, 11:13 PM

Just to share some info, parts for these couplers are hard to find. When I rebuilt mine the spring was broken and the boot was torn. I ended up buying parts here, it's a jeep parts place but some jeeps used the same coupling as GM. The boot is different but looks good when installed (and is cheaper than the one from the chevelle shops). I'll post a pic of my rebuilt shaft tomorrow.

Also, pressing that dowel pin out and then back in is a bear!

Hope this helps, Rg

http://www.quadratec.com/products/918018_02.htm

or complete coupling

http://www.quadratec.com/products/918018_06.htm

09-24-2015, 11:13 PM	#1
raggedjim Senior Member Join Date: Jun 2002 Location: Murray, Kentucky Posts: 3,402	Steering coupler info Just to share some info, parts for these couplers are hard to find. When I rebuilt mine the spring was broken and the boot was torn. I ended up buying parts here, it's a jeep parts place but some jeeps used the same coupling as GM. The boot is different but looks good when installed (and is cheaper than the one from the chevelle shops). I'll post a pic of my rebuilt shaft tomorrow. Also, pressing that dowel pin out and then back in is a bear! Hope this helps, Rg http://www.quadratec.com/products/918018_02.htm or complete coupling http://www.quadratec.com/products/918018_06.htm __________________ Roger '68 Short step - https://67-72chevytrucks.com/vboard/...d.php?t=849675 '69 ('70?) 2wd Blazer '70 GMC Jimmy 2wd Last edited by raggedjim; 10-15-2015 at 10:18 AM.