Re: My caster mod (with pictures)
I originally drilled my lowers for this mod but ultimately switched to Porterbuilt lower arms for additional clearance w/the front bags. I drilled them to move the shaft .750" forward so the PB arms added .250" to that (1" forward lowers & factory uppers). I finally got my turn on my buddys machine & I'm pretty happy w/the results:
Left Right
-0.7 Camber -0.6
6.4° Caster 6.9°
.12° Toe .12°
Rear thrust angle was -0.12°
Not bad for a dually.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 10-08-2015 at 12:31 PM.
|