Quote:
Originally Posted by oldman3
Marc, Frame is looking good...Jim
|
Thanks Jim
Quote:
Originally Posted by 99 to Life
looking good
|
Tryin...Thanks
Quote:
Originally Posted by Advanced Design
Those brakes do look huge! Way more stopping power than anything the Burb ever had.
Chassis is looking good. Good luck with the ZR2 rear Marc.
|
Yes Doug I was surprised how big the rotors and calipers were. We leave at 8:30 am tomorrow to go grab it.
Quote:
Originally Posted by 48ChevBagged
I have not been on in a while but the burb is looking great. Keep it up.
|
Thank you
Quote:
Originally Posted by jweb
Which brake kit did you use?? I think I need to upgrade since my ls1 swap
|
I went with mcGaughy. That's who's dropped spindles I'm using. 13' will be fine a 14" set up would be overkill for my stock 350 hp LS1 motor.
Quote:
Originally Posted by ChuckDriver
Brakes look good!
|
Thanks man
Quote:
Originally Posted by ptc
Looking good on the truck Marc - the Eastwood deal is pretty good for $949 if you can find it with free shipping. I payed $800 for both but I got stiffed for shipping of about $80 -$90 I think it was.
They both work great so far.... plasma cutter is doing 3/8" plate and burns right thru. I found if you use TOO much air its NOT good... trial and error!
The welder works good on 18ga, 16ga that ive been welding lately and then 1/4" and 3/8" plate too.
good luck!
|
Thanks for the info, I appreciate it.
Marc