Took some measurements to start my four link
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20160116_145104.jpg)
Started working on my driveshaft hoop/4 link mounts crossmember
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20160116_212159.jpg)
Wanted to make it look like it fit with the notches so I matched one of the angles
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20160116_212232.jpg)
Decided I was going to TIG it all. Mostly because I wanted to get more practice
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20160116_233416.jpg)
That is all I got for now.
I patched a bit of my inner fender and took a lot of pics because someone was asking about patching in the body work section on another board.
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20160116_155308.jpg)
ignore the fact that I cut the patch too small....
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20160116_161756.jpg)
TIG'ing it in
![](http://i20.photobucket.com/albums/b248/Tinydb84/Mobile%20Uploads/20160116_164905.jpg)
Filled and DA'd